Free Computer Repair Service

When installed the system, there is no CD-ROM or CD-ROM drive; although computer saved a system restore disk image file, but no burner or a blank CD-ROM; CD-ROM is scratched. If replace the CD-ROM format partitions inside the file to the operating system restore disk file you can install the system through flash memory.
First prepare the systems needed to restore and install the disk image file, and to ISO file format stored in the hard drive.
Step 1: making the best pre-U3 should first look at the complete formatting. Run Customizer, it will automatically find the plug in the U3 flash memory on the computer, locate and prompts the next step. When the screen shown in Figure 1, you can click on “Information” detailed look at for more information. Information on the general meaning is: When customers need to store image files in the U3 CD-ROM, replace the software installation files U3CUSTOM.iso on it.

Step 2: In accordance with the software “Information” described in the method, Universal_Customizer under the BIN folder, find U3CUSTOM.iso file (Figure 2), and it is replaced with pre-prepared image file, and then click Next. Production time and the size of the image file, 700MB size of the image file produced copyed U3, spent about 20 minutes.

Step 3: production after the removal of flash memory, and then re-plug flash memory. At this time, the original U3 partition the contents of the CD-ROM format, into a pre-prepared the contents of the ISO file to replace the successful. Note that if you replace the unsuccessful or can not operate normally after replacing, you can also use the official website of the “launchpad removal” software back to the U3 of the original state.

Incoming search terms:

• u3custom minutes (1)